Others

Home » Products » Fiber Tools » Others

  • img/tk_24_wire_stripper.jpg

TK-24 Wire Stripper

Contact us
  • Specification
  • Inquiry
  • Downloads

This stripper can strip cable in four lengths 4,6,8,and 12mm.The stripping length is preset to 6mm.If you want to strip other lengths,you may adjust the blade's position.

You may use the hex wrench, which is install on the bottom of the tool to adjust the blades'depth. lnsert the hex wrench into the bladedepth adjuster on the bottom of the stripper, then rotate the hex wrench clockwise (to cut smaller cable) or cou-nterclockwise (to cut larger cable).Repeat above steps to set the other blade.

The V-block is reversible. Use hex wrench to push the V-block out of the housing,align the character on the V-block with thearrow, then insert the V-block into its housing. The indicated arrow.   Recommended the RG cable size mark in front of the V-block. 6 = RG6 (5C2V), 8=RG58 (3C2V).9 = RG59/62 D=RG-174 (for HT-332D).

Press the knurled portion on the upper jaw to open the stripper's jaws.

Insert the cable you want to strip through the V-block until the cable reaches the V-shaped cable guide. Then release the upper jaw to close the jaws.

Insert your index finger into the stripper's finger ring, turn the stripper clockwise 1-4 times. The cable's insulation is cut while you turn the stripper.

Open the jaws and remove the cable. Pull away the outer jacket and dleelectric to expose the inner conductor.

Datasheet & Manual

TK-24 Wire Stripper.pdf

Certificate

totop