Fiber Stripper

Home » Products » Fiber Tools » Fiber Stripper

  • img/tk_44_fast_fiber_cleaver_ffc_01.jpg

TK-44 Fast Fiber Cleaver FFC-01

Contact us
  • Specification
  • Inquiry
  • Downloads

The fast fiber cleaver offers fast and high quality cutting performance.

For Use With Single 125 micron O.D. Fiber
Cleave Length 2.0mm to 20.00mm
Dimensions 125mm(L) x 20mm(w) x 38mm(H)
Weight 75g

Strip and clean fiber

Remove primary and secondary coatings from the fiber. Complete removal of the primary coating may be accomplished by using fiber stripper. Next, clean the fiber with alcohol and a lint-free wipe.

Load Fiber

Press the fiber holding lever down and insert the cleaned fiber into the fiber holder along the groove in the leaf spring. Line up the end of the buffer coating with the cleave length mark you would like to use. Make sure the leaf spring is horizontal until the cleaving step. Release the fiber holding lever to clamp the fiber. Hold the buffered fiber against the end of the leaf spring and momentarily press the fiber holding lever once more to relieve torsional stress.

Scoring

Lightly and slowly press down on the head to nick the fiber. The blade must be used gently in order to provide a good cleave. Slowly release head – only score the fiber once.

Cleaving

Carefully bend the leaf spring down while continuing to hold the fiber. Bend the leaf spring just enough to separate the fiber, over bending can damage the spring. Release the fiber hold lever and dispose of the fiber stub.

Datasheet & Manual

TK-44 Fast Fiber Cleaver.pdf

Certificate

totop